Sabrent EC-UEIS7 User Manual

Browse online or download User Manual for Hardware Sabrent EC-UEIS7. Sabrent EC-UEIS7 User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 17
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
Sabrent EC-UEIS7 USB 2.0/ESATA TO 3.5″ IDE/SATA/SATA II ALUMINUM HARD DRIVE ENCLOSURE WITH COOLING FAN
1. Device Setup
3.5 Inch IDE Drive:
1. Check if your IDE drive has Jumpers, if so make sure they are set to Master. (Note: Please refer to the drive
manufacturer’s website for more information regarding your specific hard drive model.):
2. Remove the screws, on the side without the fan, using the included screwdriver. Remove the panel:
Figure A:
Page view 0
1 2 3 4 5 6 ... 16 17

Summary of Contents

Page 1

Sabrent EC-UEIS7 USB 2.0/ESATA TO 3.5″ IDE/SATA/SATA II ALUMINUM HARD DRIVE ENCLOSURE WITH COOLING FAN 1. Device Setup3.5 Inch IDE Drive: 1. Check if

Page 2 - Figure A:

Figure B: 3. Plug the USB or E-Sata cable into your computer’s USB or E-Sata port:4. Flip the power switch ON:Driver Setup Windows 2000/XP/Vista/7 For

Page 3

1. Windows will detect New Hardware, and prompt you to install driver.2. Choose “Search for the best driver”.3. Windows will find the necessary driver

Page 4 - Figure C:

4. At the following prompt, click “Next”:5. Click “Next”:

Page 5

6. Assign a drive letter to the drive, then click “Next”: 7. Click on “Format this volume with the following settings:” Change the “File system” to

Page 6

8. Click “Finish”. Windows will now begin formatting and initializing the disk: 9. Open “My Computer” and verify that the drive shows up properly:

Page 7

2. You may also need to change the HDD settings from Dynamic to Basic, then format NTFS, and give it a drive letter, but you should back up the data

Page 8

To convert the disk to a GPT partition disk in Windows Vista and Windows 7: Open “Disk Management”, locate the disk in the list, right click the disk

Page 10

Figure B: 3. Locate the IDE power cable. Connect it to the IDE power port on your drive:Figure A:

Page 11

Figure B: Figure C: 4. Locate the IDE data cable. Connect it to the IDE data port on your drive.Figure A:

Page 12 - 5. Click “Next”:

Figure B: Figure C: 5. Insert the hard into the enclosure, as shown below:Figure A:

Page 13

Figure B: 6. Place the cover back on the enclosure. Screw it back in place:Figure A:

Page 14

3.5 Inch SATA Drive 1.Remove the screws, on the backside of the fan, using the included screwdriver. Remove the panel:Figure B: Figure A:

Page 15

1. Locate the SATA port on the enclosure. Plug the hard drive directly into the port.Figure A: Figure B: Figure C:

Page 16

2. Place the cover back on the enclosure. Screw it back in place:Figure A: 2. Computer Setup1. Connect the USB cable into the USB port on the enclosur

Page 17

Alternatively, connect the E-Sata cable into the E-Sata port if you require it. (Note: E-Sata connector may be a bit difficult to plug in, and may req

Comments to this Manuals

No comments